If you read only MSID_dumper &H1B0 and not the entire contents to &H600 then the designation will replace only the offset &H1B0.
While the programs read the entire contents of this sector is not the case, can replace a whole. But when there is only a reference to a particular offset is only passed an examination pretend specific offset.
AVR controller to EEPROM can be saved and the entire sector from &H00 to &H600 but would be better to only the portion (one offset).
It is possible that the substitution by the sector's interface with plowing low-level format writes the correct value of the relevant sector (Formatting using the Sony memory stick card formater). Permanent format with "correct" MSID will be possible (i dont now is it in realy - should check
)