вот и плагинчик, насколько я понимаю для камеры... подходит для 271SE B/C:
http://dl.qj.net/dl.php?fid=11725
вот инструкция:USBCAM.PRX legal module patch - By PJPSP (Real alias will not be disclosed)
This LEGAL Windows executable file patches the usbcam.prx file needed by the PSP USB camera (from v2.71), to one that is valid (v2.82).
Please note that I'm 100% sure this file contains NO copyrighted Sony code. If anyone finds the file to contain any, please delete file immediately, inform the site you downloaded it from so they can remove it from thier server.
Instructions:
1. Dump the 'Flash0:\KD\usbcam.prx' file to the memory stick. If you're on firmware v2.71SE, it could be in the 'KN' folder, not 'KD'.
2. Place it in the same directory as the executable.
3. Open the program, and Press 'Crack'. If you want to keep a backup, tick the box in the window.
4. If the module is valid, it will be updated to firmware v2.82's version.
5. The output file will be called "USBCAM.PRX2". Rename it to "USBCAM.PRX", and place it in a folder on your memory stick.
6. Flash the file with PSPFILER to
Flash0:\KD\usbcam.prx, or if you're in 2.71SE, you may find the PRX in the KN folder instead. (SEE BELOW).
PSPFILER can be downloaded at
http://dl.qj.net
To flash the file in PSPfiler wait til the MS has finished indexing, and press [Select] and then [O] to switch to English. Hover over the file 'USBCAM.PRX', and press [X] and then [O].
Press [Start] to go to flash0.
Go to the directory containing the old module (KD or KN if you're on SE). Hover over the old file and press the following buttons:
[L]+[<]+[R] To activate HACKER MODE.
[X] and then [/\] to paste the file. Choose to overwrite.
Done!
насколько я понимаю, этот prx во флеш писать надо???!!!
с этим не шутят....ЗЫЗу то не хоцца калечить... а то
добавлено через 15 минут
а вот и второй релиз Usbcam Fixer (b):
http://dl.qj.net/dl.php?fid=11739
Instructions:
1. Dump the 'Flash0:KDusbcam.prx' file to the memory stick. If you're on firmware v2.71SE, it could be in the 'KN' folder, not 'KD'.
2. Place it in the same directory as the executable.
3. Open the program, and Press 'Crack'. If you want to keep a backup, tick the box in the window.
4. If the module is valid, it will be updated to firmware v3.02's version.
5. The output file will be called "USBCAM.PRX2". Rename it to "USBCAM.PRX", and place it in a folder on your memory stick.
6. Flash the file with PSPFILER to Flash0:KDusbcam.prx, or if you're in 2.71SE, you may find the PRX in the KN folder instead.