BaryonSweeper - эмулятор сервисной батарейки JigKick для анбрика PSP

[Valera0141]

Сделал самодельный разъем. Смоделировал корпус, распечатал на фотополимерном принтере, контакты взял с какого то старого разъема. Сами контакты зажимные. Получилось немного выше родного, зато контакт более надёжный.

[jas0npc]

Сообщение от Valera0141 Сделал самодельный разъем. Смоделировал корпус, распечатал на фотополимерном принтере, контакты взял с какого то старого разъема. Сами контакты зажимные. Получилось немного выше родного, зато контакт более надёжный.

Amazing, could you please attach the Gerber files for use with online pcb makers.

[Valera0141]

Сообщение от jas0npc Amazing, could you please attach the Gerber files for use with online pcb makers.

Are you talking about board files?

[jas0npc]

Сообщение от Valera0141 Are you talking about board files?

Yes please my friend. Jlcpcb and pcbway only accept gerber files

https://support.jlcpcb.com/article/6...-pcb-to-gerber
hope the above link helps

[Valera0141]

Сообщение от jas0npc Yes please my friend. Jlcpcb and pcbway only accept gerber files https://support.jlcpcb.com/article/6...-pcb-to-gerber hope the above link helps

Fine. I'll prepare the files tonight and send the link.

[Valera0141]

Сообщение от Valera0141 Fine. I'll prepare the files tonight and send the link.

Added an archive with gerbera files for ordering in my repository. You can download and watch.
github grbl download

[jas0npc]

Сообщение от Valera0141 Fine. I'll prepare the files tonight and send the link.

Thank you my friend, I have already uploaded to jlpcb, Looking forward to making your project

[Valera0141]

Сообщение от jas0npc Thank you my friend, I have already uploaded to jlpcb, Looking forward to making your project

I hope that you have downloaded the latest version of the board, as there were some changes and the code was added for them.
The new code should work on older versions of the board, only the debug LED may not work properly.